A few of the latest technical replies from the Welder Series inbox.
Category: dear welder series
Paul Horton’s replies to actual tech emails.
Dear Welder Series… front panhard suggestion?
Here is my front end set-up pics. I would like to mount a pan hard bar? I'm open for suggestions.
Dear Welder Series… 67 Nova Mustang II?
Hello I am doing some research on aftermarket 67 Nova suspensions, could you please let me know what you offer?
Dear Welder Series… triangulated four link
I'm interested in your Triangulated 4 Bar kit but i want to use Heim Joints not Bushings can you help me?
Dear Welder Series… Mustang II for ’65 Mustang, rack mounts
I specifically wanted to know if you have crossmember kits for 65 Mustang cars?
Dear Welder Series… 60″ MII rack mount spacing
Are the mounting holes for the rack and pinion setup at 16" or 15 1/2" on center??
Dear Welder Series… two Model ‘A’ pedal questions
Dear Welder Series…
I am building a Model A style frame and I am going to use manual brakes on it. Which master cylinder bracket kit and pedal should I use?
Ryan
Dear Ryan…
If you are using an automatic transmission, the WS13704 kit was designed for the Model ‘A’.
It is available ready-to-weld or welded.
Is this the frame that you got the frame curves for?
Thanks for looking at Welder Series, Ryan.
Paul Horton
Dear Welder Series…
Great products, great videos and product info on YouTube.
Can you recommend which master mounting bracket and pedal to use for a
model A, and is there one available that has both the brake and clutch
pedals?
Thanks Alan
Dear Alan…
Thanks for looking at our parts, Alan. Check out 20281. Any clutch and brake is very crowded in a Model ‘A’. We can swap the offset brake pedal for one with no offset. Then you can bend both pedals symmetrically to go around the steering column.
I hope we can help you with your project.
Paul Horton
Dear Welder Series… Mustang II for ’52 Dodge- pics!
Here's a photo of my frame. Just an old '52 Dodge, that I saved from the crusher. I'm concerned about the spring tower angle (from horizontal) It's about 15 degrees. Is that correct?
Dear Welder Series: Mustang II for ’51 Chev Fleetline?
I am not sure which kit I need. I am working on a 1951 Chevy Fleetline and I do not know where the measurements on your kits originate. ie outside frame or inside.
Dear Welder Series… 4′ sway bar?
I am building a custom full size truck, and the current series sway bars you offer are not going to be long enough for my application.
Dear Welder Series… Four Link Question
I have a 1956 Chev truck and want to put a 4 link in the back. I was thinking of a triangulated one. Would that work?
Dear Welder Series… four link setup
I'm about ready to start fabricating the rear section of the frame and I was wondering if you can give any tips on how to rig up the rear suspension/frame so I can get the car as close to the ground as possible without loosing to much headroom since the car is going to be chopped.