...on the other end. Upper bars are about 18″ c-c and lower bars are about 25″ c-c. Coil-overs can be mounted in one of three holes on the axle brackets....
Triangulated Rear Four Link Package, for Air Springs
Search for must II rack mount - 125 results found
Coil Over Mounting Kit
Upper coil-over mounts, typically used on Model A rear crossmembers. Sold in pairs. Available fully tig welded or ready to weld. Plates are 3/16″ mild steel, tubes are 1″ OD...
Four Link Kit – Pro Street
...Heavy-duty, 1-3/4″ wide urethane bushings and inner sleeves are included. The axle brackets have a 1/2″ hole to mount the coil-over and a 3/8″ hole to mount a sway bar...
Frame Plate; Versatab
Buy 10 of one part number, get 10% off. Buy 50+ to get them for half price! Sorry, no additional discounts applicable. Use this plate as a motor mount frame...
Parallel Rear Four Link Kit
This kit has proven to be adaptable to many frames. The bars mount beside the frame rail (inside the frame or outside, as shown in the pics). The upper bar...
Rear Crossmember Kit
A simple upper coilover/ shock mount crossmember for your rear suspension. Crossmember kit to mount the top of coil-overs or ShockWaves in any frame that is 46″ or less between...
1956 International Pickup Mustang II
...systems with more than 2 U joints. Modified Welder Series pedal mount. Welder Series Mustang II crossmember #2115 transmission crossmember. C005 engine mount kit. Parts Used: Click to share on...
Dear Welder Series… 1937 Dodge D5 Mustang II?
...to mount the crossmember and then trim off the top of the frame to mount the upper towers. The kit you use will depend on the track width you want...
IFS: Make Your Own
...and at the back. These dimensions will give the stock Mustang II anti-dive angle of 4 degrees. 1974-78 Mustang II stock upper control arms measure 8″ from the cross-shaft center-line...
What do you mean, “modify the rails”?
...1953 International Mustang II 1953 International Mustang II 1940 Dodge Mustang II 1940 Dodge Mustang II 1940 Dodge Mustang II 1940 Dodge Mustang II If you’ve put our in something...
Mustang II Installation: 1957 Ford
Garth Webb (www.webberchassis.com) installed one of our Mustang II kits in a customer’s 1957 Ford, and I followed along with a camera. Hopefully this will give some insight into what’s...
’32 Update… Ride Height Gauge (article 57)
...was broken, indicating optimal ride height. We discussed the idea with John and Zac at Classic Instruments and they suggested two fuel tank sensors, one mounted on either side, running...
Installing Small block Ford Engine Mounts
Lowdown Hot Rods installed a set of our #2050 small block Ford engine mounts in a ’32 Ford chassis. Mock the motor in position, considering firewall/ distributor clearance, radiator/ fan...
Ford 8.8 Upper Four Link Bars
...a copy) for ideas. After deciding on parts LS204 and LS208 from our LS1 motor mount kit, he trimmed, notched, and welded them to the end of a bar. Now...
Sway Bar Install: JH Restorations
...but it will give us a place to mount our sway bar. Once we have determined where we want the bar we used a hole saw and cut out both...