Jeremiah, the Welder Series 56" kit would be the one to install in your 36 Chev (1/2 ton?) truck.
Category: dear welder series
Paul Horton’s replies to actual tech emails.
Dear Welder Series… ’56 Chevy Mustang II?
Which one of your fully welded Mustang II kits would you recommend?
Dear Welder Series… cherry picking
The parts listed below were shown as part of a Mustang II kit but I wanted to see if I could purchase them separately. If so, what is the pricing?
Dear Welder Series… four link bar location
Do you foresee any problems with placing both the upper and lower arms outside of the frame?
Dear Welder Series… shock travel question
Is it normal that I only have 2-3/16" for vertical travel on my shocks?
Dear Welder Series… Mustang II for 1937 Plymouth?
I am not sure how to measure the track width. Do you have this assembly?
Dear Welder Series… Mustang II for ’63 Ranchero?
I am wanting to put a Mustang II crossmember in my 1963 Ranchero. Will one of your kits work for that application? thanks
Dear Welder Series… C notches for ’38 Chevy?
Dear Welder Series…
Do you have a frame C notch kit for the rear suspension of a 38 Chevy?
Dear Fred…
Thanks for asking, Fred. If you want to put a simple c-notch in the bottom of the frame rail for rear end clearance, we have #12203.
We also have the frame curve sections, as shown here .
I hope one of these will solve your problem.
Paul Horton
Dear Welder Series… spring over axle?
Looks or not, is rearranging the spring location from in front of, to over the axle done and is it a matter of “builder’s choice”?
Dear Welder Series… 1962 Meteor Mustang II?
I have a 1962 Mercury Meteor I would like to install a Mustang II kit in. I would like to know exactly how to measure the track width.
Dear Welder Series… 1933/34 Ford Vega Mount Location?
In your #2072 Installation Tips on Model A and 32 Fords you reference a measurement from the radiator mounting hole for the Vega Steering Box Bracket, do you have a measurement for 33/34 Fords or an article I can reference?
Dear Welder Series… What Kind Of Steel Do You Use?
What kind of steel are your tabs and gussets made from? Mild Steel?
Dear Welder Series… tig info
Would a Miller Maxstar 150 be powerful enough to do the nice (and quick, I might add!) tig welding I see being done on your videos?
Dear Welder Series… What diameter are your sway bars?
Do you make your universal sway bar in 0.500 inch diameter. The 48 Plymouth Conv I'm working on never had a rear sway bar and I may not be able to use anything greater than 0.750 on the front.
Dear Welder Series… Motor Mounts for 1973 Javelin?
Working on a 73 Javelin with a chevy big block conversion need idea on motor mount fabrication for this application.