Category: dear welder series

Paul Horton’s replies to actual tech emails.

Dear Welder Series… Mustang II crossmember dimensions?

Dear Welder Series…
Interested in your mustang II crossmember with coil overs.  How much does the crossmember weigh and how wide is it outside to outside at the lower control arm mount?  Thanks.  Steve.

Dear Steve…
The 56″ crossmember kit (shown below) with the upper arm brackets and coil-over mounts weighs 32 lbs.

The two crossmember pieces and the plates that run from the top of the crossmember to the inside of the frame weigh 19 lbs.

The lower control arm holes are on 22-1/4″ centers.  If the center line is extended each way, the crossmember dimension is 25-5/16″.

I hope this helps.

Dear Welder Series… Four Link for 1965 Mustang?

Dear Welder Series…
Hi, I’m after a rear 4 link for my 65 mustang for general road use, no racing, do you have a setup similar to [the other guys] setups & if so prices & cost of  shipping to California 90200, USA, unless you good rates to New Zealand, if you can help I’ll phone you.

thanks Rob.

Dear Rob…
Rob, Welder Series has a parallel and a triangulated rear 4-link.  Both kits are “universal”, meaning they can be used in a wide range of applications, but they require modifications (mainly bar length) to use in your Mustang.

Here are the kits:

The parallel kit will need a Panhard bar:

Freight cost to California would be 10% of the order total with a minimum charge of $15 and a maximum charge of $60.00.  All of our prices are in Canadian Dollars.  We can ship to New Zealand by Parcel Post and would quote a rate based on what you would like to order.

We are working hard at getting the website picture issues resolved.

Thanks for looking at Welder Series parts.