Dear Welder Series…
On your Ford motor mount kit do you use the big urethane bushings? If so, can I buy a motor mount kit without the bushings and sleeves as I already have a set here I bought earlier from Welder Series.
I would like to have the kit un-welded. All steel parts except the bushings (and bushings sleeves of course)
Louis, the 2050 kit used the smaller urethane bushings. You could piece a kit together to use the large bushings. I’m sending this list of parts in a separate email.
Grant Schwartz has sent in some pictures of his 302 installation into a 1974 MGB. He modified the 3/8″ engine block plate and welded a section straight down from the mounting holes.
I am restoring a 1971 mustang coupe. I would like to add a 4-link rear suspension and a coil over front suspension.
Lowdown Hot Rods installed a set of our Ford engine mounts... follow along!
I am fairly sure the 56" cross-member kit is the correct one for use on my 64 Ford Falcon 2 door hardtop, but is there anything else I should be aware of?