Dear Welder Series…
Looking at the brake booster kit WS24806. Can you get the same kit but with a pedal arm that is flat with no kinks or bends. If so, will it be the same price?
Thanks
Jay
Kelowna BC
Dear Jay…
We can sub any pedal in the kit Jay. Here are the parts and pieces of pedal kits.Transmission Crossmember KitProduct DetailsBrand: Welder SeriesThickness: 3/16" bracketLength: Tube: 42"Tubing Size: 1-1/2" OD x .120" wallGreat for simple frames, this kit will let you drop the transmission straight down, and the dual bent tube design gives you the ability to place the tailshaft where it needs to go, even a few inches below the frame rail, in almost any frame.
This kit is a simple spin off of our more complete WS132500 kit, but it would be great for simple frames or to add a drop-out transmission crossmember to an existing center section.
The bent tubes allow you to install the transmission lower than the bottom of the frame rails, and by using two tubes, it will fit basically any width frame, from a narrow Model A or pickup to fat fendered Fords.
By adding two bent notched tubes, you can create a simple K member, triangulating from the lower tubes forward and up to the top of the frame rails.
Kit includes two bent tubes, 6″ center tube, four flanges, formed mount, and hardware.
We would credit the arm #213211 (standard in the kit) and invoice for the pedal you want.
Thanks for looking at the flexibility of Welder Series part numbers.
Paul Horton
