Dear Welder Series… 2-3/4″ rear axle brackets?

Dear Welder Series…
Do you make any parallel 4-bar axle brackets designed for the 2 3/4″ S/10 Blazer axle?

Dear Jim…
Our brackets are made for a 3″ diameter tube, but you can make an “adapter” ring from 3″ x 1/8″ wall tubing to reduce the diameter to 2-3/4″.  This adapter only has to go half way around the axle tube. It wouldn’t have to be longer than 2″.

Thanks for asking.

Paul Horton

3 comments

  1. Jim Auge says:

    good info!!! I just purchased a s-10 rear axle and have your Regular brackets for 3″ housing The s-10 housing is just the right length for a cheaper hot rod build.

  2. Jim Auge says:

    I used the tubing suggested to make your brackets work on my S-10 rear axle. The tubing was hard to find you may want to sell this tubing for any one wanting to use your 4 link system.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.