Tag: installation

Dear Welder Series…
Good Day. Looking for a Mustang 2 type cross member for a 37 Dodge D5 coupe. Can’t find anything on your site. Would you have such a thing? Price and how much to ship to A0L 1A0? Thanks Gary

Dear Gary…
Hi, Gary. Your Dodge frame has a high curve over the front axle which makes it more difficult to install a Mustang II front end. It would be good to read our instruction sheets. https://shared-assets.adobe.com/link/17afad9a-b219-4191-7cfb-7ee4bfa6277c/?file=Coil%20Spring%20Mustang%20II.pdf , and eye-ball “ambush” areas. It might be necessary to add to the bottom of your frame to mount the crossmember and then trim off the top of the frame to mount the upper towers. The kit you use will depend on the track width you want and if you plan to use stock-style springs and shocks or coil-overs. Thanks for looking at Welder Series parts. Once you decide on the kit you’d like, we can dial in the freight cost.

Paul Horton

Dear Welder Series…
Hi Paul Thanks for your informative reply. I will have a closer look at what I have and go from there. Now I said Mustang II front end, but it doesn’t have to be. Is there something else that would an easier install using the stock rails? Gary

Dear Gary…
Hi, Gary. A nice thing about the Mustang II is that new parts are readily available. Coil springs and coil overs are available with a wide range of rates so that the front end gets installed knowing that the ride height and the ride quality you want will happen when the vehicle is finished. Another advantage is that most, often all, sheet metal, bumper, and rad mounting holes can be used because the MII gets installed in the stock frame. I hope this info helps.

Paul Horton

1934 Plymouth Mustang II Installed

I recently made the front clip for my project (1934 Plymouth 2 door sedan). It was a pleasure using your Mustang II crossmember kit! My job was easy because the rails are level, square and plumb but the directions were a great help and easy to follow. Thanks for a great product!

Jeff

You can also see how Jeff made a mock-up coil over using a tube with two tubes welded on the ends. This is always a good thing to have around to keep your car at ride height during the build. Remember, you use the coil over spring to support the car at the designed ride height.

Do you have some Welder Series parts on your car? Please consider sharing them; it’s always helpful to see other people’s work.

Thanks for using our parts, Jeff. Enjoy your Plymouth!

DW