“Canuck” over on the HAMB sent me this information on a possible candidate for a brake pedal return spring. Here are the original dimensions of the spring (the one in the picture has been trimmed): OD = 1.655″, ID = 1.375″, Length = 3.575″, Wire Dia = .135″, 6 coils, Min length when coils bind = 2.768″, Compression = ~~ 22 lb.s/inch compression. Straight spring, no taper. This came off an ’89 Cadillac Fleetwood.
Thanks for keeping me in mind!
If you didn’t see my pedal return setup, here’s a picture:
Here’s a setup that Lowdown Hotrods made… it looks like they’ve used a tube threaded on to the booster plunger with a jam nut sandwiching an aluminum disc which holds the spring. You can always expect clean work from these guys! Check out their site for a whole bunch of project pictures.
Do you know were I can find a spring f or the brake return.
I’m not sure where you’d get one, but the spring in the picture came from a 1989 Cadillac Fleetwood.