Some 'highlights' of my fuel line install...
Author: DW
Tech Tip: Brake Line Tabs
I used these little front panhard tabs (Welder Series part #219445) to hold the front section of my rear flex lines.
Rough Assembly with Urethane Bushings
When you're putting stuff together that uses urethane bushings, only put one half of the bushing in. It will hold the inner sleeve, and it will be a heck of a lot easier to remove when it's time to paint.
Using a Short Water Pump on a ZZ4
To use a short water pump on a ZZ4 engine, you will have to relieve (read "grind") some points on it so that it will clear the plastic timing cover.
’32 Update: Radiator Support Rods (article 14, archived)
First, decide where you want the brackets. I opted for a wider than normal stance, mainly because I thought it would look "planned" for the rods to line up with the wiper posts, and the steering wheel center on the drivers side.
’32 Update: Steering Linkage (article 15, archived)
I was hoping to use only two u-joints for this car, but after mocking it up and finding that the shaft is too close to the header, it'll have to be three.
Dear Welder Series… Watts link brackets?
I'm wondering about your brackets 21842. I'm building a watts link and want to use a bracket similar to what you have. But can I simply bent one backwards and have a left and right side bracket?
JH Restorations: Sway Bar Install
I received these pictures from JH Restorations as submissions to our monthly photo draw, and as I looked at the rest of the pictures in his Facebook album, I thought they would be good to use on our site too.
Frank Wall: Canadian Street Rodding Hall of Fame Inductee
Frank Wall of Tecumseh, Ontario was inducted posthumously into the Canadian Street Rodding Hall of Fame on September 11, 2010 at their annual gala held in Waterdown, Ontario.
1966 Mustang Rear Four Link
I have a 66 mustang that needs a new rear suspension. I am interested in your 4-link rear upgrade.
New Product: Threaded Spacers
We just added two threaded spacers to our web store - 1" OD, 1-1/2" long, one threaded 5/8-18 and the other 3/4-16.
New Product: Rear Crossmember Kit for Coil-Overs
Crossmember kit to mount the top of coil-overs or ShockWaves in any frame that is 46" or less between the frame rails.
MyRideisMe.com: Wind Tunnel Testing: Is it just blowing smoke?
If you're into going fast and what it takes to get fast, this is a really interesting article on wind tunnel testing.
’32 Update: Control Your Air Ride Exhaust (article 55)
Here's a tip for controlling your rate of decline, allowing you to fine-tune the ride.
Attention Texans: Stolen Roadster
This ’32 Roadster was stolen in San Antonio on the 12th of October. It was in an enclosed trailer, which was also taken with the tow vehicle.
