Dear Welder Series…
Hi, I contacted you last year before Christmas sometime and was going to order up a rear 4 link with air bag brackets. Since then things have changed and now I will be doing the same thing but with a smaller axle. It is the gm 8.5″ from an S10. The axle tube dimension is less than what your brackets are cut for. Do you have a different axle bracket to fit the smaller axle tube diameter? Or do you have a suggestion for my problem?
thanks,
Dennis

Dear Dennis…
Builders have used a short length of tubing, 3″ O.D. and the same I.D. as your axle tube, as a bushing. Split the tube into 2 “C” halves. This will make up the difference in the axle to bracket diameter. It will also spread the load over a wider area for more strength.

Thanks for asking, Dennis.

Dear Welder Series…
Hi Paul,

Dear Dennis…
I have a similar bracket that was designed for the Ford F1 truck. One bar mounts just above the bottom of the frame rail and the other is lower. Will check it out when I get a few minutes.

Thanks for asking.

Paul