Dear Welder Series…
I’m wondering about your brackets. I’m building a watts link and want to use a bracket similar to what you have. But can I simply bent one backwards and have a left and right side bracket? One for the top left and one for the bottom right side. Also do you have a tube with a 3/4″ hole? I have 3/4″ heims on order.

One other thing, do you have them in a shorter size? Like about 2.5-3″ tall? That would work a lot better for my setup.

Thanks for your time, Jesse

Dear Jesse…
Yes, these can be bent either direction, Jesse. (But they will look the same bent either way.)

Tube #20952 is 1″ OD x 3/4″ ID x 2-1/4″ long. The notch in the 21842 is 7/8″ diameter, so it would have to be opened up 1/16″ to 1″ for these tubes.

The 21842 is only made in that one size. The center of the welded tube is about 3″ above the top of the axle tube.

Thanks for looking at Welder Series parts.

Paul Horton