Axle Bracket kit for triangulated rear 4-link. The upper tabs are cut to fit the axle tube at an angle. Holes for 4-link are ½” diameter. Designed for 1-3/4″ wide urethane bushings. Coil-over mounting holes are backed with a 1” square block for extra support. The 3 coil-over holes are 5/8″ diameter on 1″ centers. The lower coil-over hole center is 4-1/2″ below the bottom of the axle tube. Made to fit 3″ diameter axle tubes.
Available with or without upper axle tabs, for 3" or 3-1/4" diameter axle tubes. 3-1/4" brackets are only available for large bushings.