Engine mount assembly (available artfully TIG welded or as pieces which you can weld together without special fixtures)
4 frame plates, long enough to fit in pretty much any chassis from a Model A to an F100 pickup
All necessary grade 5 zinc plated hardware
Frame plates are 3/16" mild steel. Main engine plate is 1/4", gussets are 3/16".
3" from engine side of plate to urethane bushing center. The single 3/8" slotted hole center is 3-1/8" from the round 3/8" hole centerline. Round holes are 3-1/2" center to center.
This kit will work with all SB Chev blocks which have the 3 bosses on each side of the block. This would be all blocks, including LT series, up to the LS series except some 1955/6 265 blocks that were cast without the side mount bosses.
These use 1-3/4" wide Energy Suspension polyurethane bushings (made in the US).