Problem solving hot rod chassis parts for 47 years.
Old Products: threaded stuff
When we ran a full service chassis fab/turn-key hot rod shop a number of years ago, it was always useful to have threaded things around to weld into the frame for some kind of mount, etc.
Here’s a list of all our threaded things for your reference:
Buy 10 of one part number, get 10% off.
Buy 40+ to get them for 40% off! Sorry, no additional discounts applicable.
Priced individually unless you order "one of each".
Supplied flat, this 10 ga. Mustang II rack mount is available with a slot or a hole.
This mount will rotate the rack input shaft down 20 degrees to make it easier to connect to the steering column. The mounting hole is 5/8″ dia. The center of the hole is about 1-3/8″ from the front face of the crossmember.
The slotted rack mount is used on the passenger side of the crossmember so both early and later Mustang II racks can be mounted. The mounting hole is slotted 1-1/8″ x 5/8″ dia. 10 ga. steel.