Problem solving hot rod chassis parts for 40 years.
Old Products: threaded stuff
When we ran a full service chassis fab/turn-key hot rod shop a number of years ago, it was always useful to have threaded things around to weld into the frame for some kind of mount, etc.
Here’s a list of all our threaded things for your reference:
+3
Engine Mount Kit - Chevy small or big block
215950
C$150.00
In stock
1
Product Details
Brand:Welder Series
MPN:215950
Country/Region of Manufacture:Canada
Parts included:
Engine mount assembly (available artfully TIG welded or as pieces which you can weld together without special fixtures)
4 frame plates, long enough to fit in pretty much any chassis from a Model A to an F100 pickup
Urethane bushings
All necessary grade 5 zinc plated hardware
Frame plates are 3/16" mild steel. Main engine plate is 1/4", gussets are 3/16".
3" from engine side of plate to urethane bushing center, and 6" from bushing center to the far end of the trim-to-fit frame plate. 10" plates are also available. The single 3/8" slotted hole center is 3-1/8" from the round 3/8" hole centerline. Round holes are 3-1/2" center to center.
This kit will work with all SB Chev blocks which have the 3 bosses on each side of the block. This would be all blocks, including LT series, up to the LS series except some 1955/6 265 blocks that were cast without the side mount bosses.
These use 1-3/4" wide Energy Suspension polyurethane bushings (made in the US).