When we ran a full service chassis fab/turn-key hot rod shop a number of years ago, it was always useful to have threaded things around to weld into the frame for some kind of mount, etc.
Here’s a list of all our threaded things for your reference:
Laser cut from 1/4″ steel. Holes for adjusters are 5/8″. Designed to use 21″ center to center bars. Can be used with our urethane bushed adjusters or spherical rod ends. The coil-over hole is 1/2″ so a spherical bearing can be used, or you can drill it to 5/8″ for coil-overs with 5/8″ urethane bushing ends. The radius around the bar holes is the same as our #1205 urethane bushing outer tubes, but heim joints can also be used.
The coil-over hole is 6″ below axle centerline. The 3/8″ upper hole is for a sway bar mount. From the center of the lower 4-link hole to the enter of the upper hole is 11-1/2″. The 1-1/2″ hole below the axle can be used for tubular reinforcement.
This plate can be used with #212412.
Priced each.
