Dear Welder Series…
I am interested in buying your 4 Link bracketry; does it come with, or can you provide, some instruction of how to locate the frame brackets relative to the axle brackets? This will be used on a street car with a blown Big Block.

I’m thinking that the lower bars should be installed parallel to the ground, or a tad up in the front. Should i do this using the “middle” holes on the bottom of each bracket and give adjustment both up and down? Or, what do you suggest?

Thanks!!!!

Don

Dear Don…

Don, the part above takes you to the triangulated 4-link page. Scrolling down, you will come to some links that give the info you are asking about. The frame end of the lower bar will be 1/2″ higher than the axle end, so you are right. I like to build using your “middle hole” reasoning, too.

Thanks for looking at Welder Series’ parts.

Paul Horton