Dear Welder Series… 67 Nova Mustang II?

Dear Welder Series…
Hello I am doing some research on aftermarket 67 Nova suspensions, could you please let me know what you offer? I wasn’t able to find what I was looking for on your web site, Thank you!

Dear Bob…
Bob, Welder Series produces Mustang II kits for stock springs and shocks and for coil-overs. Usually, Nova builders fabricate a frame section from the firewall forward. Often this section is reinforced with tubing to the upper firewall area. The Mustang II kit can then be welded to the frame section. Either of our 56″ kits will work well in this application.

Paul Horton

5 comments

  1. Bill Watson says:

    Great products! I saw your products on Trucks and it got me thinking, “Hey, I can do that”. My question is whether you have a rear 4-link for fitting a 8.8 in a 67 mustang. I saw the correct m2 crossmember to use.
    Thanks and it appears the Trucks plug has done wonders for you. Good job.
    Bill

  2. Stephen Ledak says:

    I must say, I have purchased and installed the 60″ Mustang II cross member on my 1949 IHC KB-2. Paul was a GREAT help in helping this 1st time modifier get through the process of the cross member installation. I have since purchased a few more items from Paul and the quality is the best!

    Check my build page.

  3. Rick says:

    I am building a 52 Dodge “Job-Rated” with a 440 big block, as you probable kn ow not to may people doing this. Do you know which of the welder series Mustang II setups I would need and do you make a motor mount?

Leave a Reply to johnnyCancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.