Dear Welder Series… Engine Angle Question

Dear Welder Series…
I am building a 37 two door sedan. I have put in one of your Mustang II front suspension kits, which worked fine. Now I am installing the motor, which is a 1999 LS1 5.7L. My question is how important is the three degree tilt back on the engine. Three degree will work but 5 degree would put the tailstock below the the top of the frame and would mean less floor modifications. I did just purchase one of your center section kits but it is not going to work the way you [supplied] it, because the drive shaft is too close to the top of the frame. I will be using all the pieces, just laying it out differently. Any feed back would be appreciated.
Thanks

Ray

Dear Ray…
Ray, 3 or 5 degrees will be fine. We normally set engines up at 4 degrees and that extra bit won’t hurt anything. Check out the link below for motor mounting tips.

http://welderseries.com/tech/tech-sharing/motor-mounting-tips/

Please send pictures of what you do with our center section… it’s always nice to see our parts ‘in action’.

Thanks for using Welder Series parts.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.