...stance was a sport, this would medal!” ATC ringer tee, 60% cotton/ 40% polyester. Heather grey with black neck and sleeve trim. Design: Problem Child Kustoms. Facebook Email Pinterest Print...
T Shirt: Wheel Well
Search for problem child - 13 results found
T Shirt: Shop Scene
The latest Welder Series T shirt was designed by Problem Child Kustoms and features a shop scene with our ’32. Lots of detail! Gildan Heavy Cotton shirt, 100% cotton. Available...
Friends of WS
...NotStock Photography (John Jackson) Widely considered one of the top automotive photographers in the industry. Problem Child Kustoms (Brian Stupski) Widely considered one of the top automotive designers in the...
Testimonials
...and will make a solution to your problem… and probably at the best price around to boot.” Mike in Green Bay, WI. Follow Mike’s ’47 Ford 1.5 Ton pickup build...
Contact/ Shipping Info
...steer requires spindles with proper rear steer geometry, otherwise you'll have more issues than just a visual problem with the splash apron. Using a complete system like the Heidts Superide...
Dear Welder Series… crossmember only?
...to fit. I've seen some 1934 trucks with independent front ends.I know the the fenders bolting to the top of the frame are a problem with regular mustang II What...
Dear Welder Series… 1962 Studebaker Lark Mustang II
...a problem? Dear Dan… Dan, that should be fine. I’ve attached cut line drawings. This “assumes” 2×4 rails, parallel to each other and level. The bottom of the frame would...
Dear Welder Series… 1977 F100 MII?
...problem is all of the ifs kits that I have run across all claim 3-5” drop. I’m looking at the wealth of knowledge on your website and from my thinking...
Dear Welder Series… Splined sway bars vs Pinned
...suitable alternate splining shop. The pinned ends have never given any problem that we are aware of so the decision was made offer both ends pinned until the one-end splined...
Dear Welder Series… Brake/ Clutch question
...this such a thing? My thinking is, by utilizing a hydraulic clutch the problem with clutch linkage is done away with, and the pedal configuration can be worked out within...
Dear Welder Series… trimming excess off crossmember
...You can trim the area indicated. But it feels like there’s another problem coming regarding the towers. It looks like the frame is too narrow to attach them. Have you...
Dear Welder Series… No Door Mustang II?
...trucks! these things wander all over the road when lowered, and are a handful to drive. one problem is steering column ends up in front of the axle, but with...
Mustang II Application Chart
...there are any problems putting the welder series coil over mustang setup under my full fended 34 fordoor any interference with fenders thanks Scott DW Hi Wade, you'd use the...