Dear Welder Series… 1976 Datsun 260Z Mustang II

Dear Welder Series… 
I’m customizing a 1976 Datsun 260Z for a client. It has an all aluminum Mustang Cobra 32V V8 up front and a narrowed 9″ triangulated 4 link setup in the rear. I want to put something like your Mustang II IFS kit on the front and get rid of the struts so that I can mount a wider torque thrust II wheel to match that back.

The frame rails have a lip that sticks out a little on the bottom facing out, and the width from that outside edge to outside edge is 32″. They are smooth on the inside.

Do you have something that will work for me? If you do, can you send me other dimensions so that I can measure up to make sure everything will fit under the original fenders?

Any help would be appreciated,

Thanks.

Brett

Dear Brett…
Our Mustang II coil spring kits are designed to be installed in almost any frame. What measurement do you want between the wheel mounting surfaces? (Where the wheels are against the rotors…)

What diameter tire will you use on the front?

With the frame at ride height, what is the distance from the ground to the bottom of the frame at the spindle location?

As above to the top of the frame?

With this info, I’ll be able to tell you about installation issues you might run into and suggest ways around them, if necessary.

Thanks for looking at Welder Series parts.

Paul Horton

Dear Welder Series…
Thanks for getting back to me.

There are a lot of questions there that I don’t have the answers to yet.

I’ve just finished the back end of the car, so let me measure the front up this weekend and I will get back to you.

Cheers,

Brett.

Dear Brett…
Thanks, Brett. I might be slower getting back to you for the next week or so… There will be days when I’m out of internet access. I’ll try not to keep you off the road too long…

Paul Horton

Dear Welder Series…
Here are those numbers!

What measurement do you want between the wheel mounting surfaces? 54″

What diameter tire will you use on the front? Don’t know yet, but to match the rear the center of the front spindle will need to be 12 3/8″ from the ground.

With the frame at ride height, what is the distance from the ground to the bottom of the frame at the spindle location? 11″

As above to the top of the frame? 14″

This car is pretty low, so if we need to go up or down a little, I would prefer to go up a little on the ride height. We have a tri-4-link with coil overs on the back so we can always adjust the back up or down to match whatever the front ends up being.

Cheers,

Brett.

To Be Continued…

Leave a Reply