Tag: flat crossmember

April 2018 Photo Sharing

Thanks to everyone who sent in pictures of how Welder Series products are being used on your projects through the month of April. Hopefully these will spark an idea that you can use on your own project! See below the gallery for links to products shown. The winner (chosen at random by random.org) has been notified and a $50 credit has been applied!

Submit your own pictures here.

Dear Welder Series… Model A front axle question

Dear Welder Series…
Hello,
I just wanted to thank you for your catalog.
I am going to attempt at 64 years old to build my first hot rod on a fixed income(retired).
It’s a Model A full fendered and my question is can I use a stock 48 Ford axle (48′) with your flat front cross member,a reverse eye spring and 500 or 560-15 front tire and A)get the required drop or stance and B) will the front tires stick out too far into the fender as the 48 axle is 1 inch wider on each side.
Again many thanks,
Bryan

Dear Bryan…
Good questions. I’ve been sitting looking at your email for a few minutes trying to decide how to answer them. And it comes down to: “It depends…”

It depends on the stance you want. A starting point might be to put the axle and wheels/tires that will be used under the car with no spring mounted. Use a short (4” long?) 2×4 on edge, running front-to-rear, on top of the axle and under the stock front crossmember. This mock-up will be about as close to a low spring arch as you can get. If you are ok with the tire width and fender clearance at this height you can consider going lower.

The flat crossmember will let you lower the front a maximum of 2” compared to the stock crossmember. The stock Model A rad bottom tank drops down into the stock crossmember area. The rad shell hides the upper and lower tanks and the side straps. Our flat crossmember will use up the space that the lower tank wants, so a custom rad would be required. The rad shell would not hide the bottom tank. This is something to consider.  

I hope this gives you some help with your build. Thanks for looking at Welder Series parts.
Paul Horton

Dear Welder Series…
Thank you very much for your info Paul.
You have provided me some tips that I never knew in spite of reading hot rod magazines for 50 years.
Take care,
Bryan