D100 Build, Article 4: Rear Bump Stops

I always appreciate a good “reusal” of parts to either change their intended function, or to keep their original function but in a slightly different way. Using body trim tastefully from one model on a different car comes to mind. The reused part needs to fit the theme, however, and not merely look like it was used because it was 8:45 on a Sunday night, and the auto parts store workers were on strike.

In removing the original leaf spring rear suspension on the Sweptline, I ended up taking the bump stops off the frame too. They weren’t lined up with axle centerline, and I decided I could use the space outside the rails where they were sticking out. Also, they were going to be in the space I needed to remove for step notch clearance. I like the piece itself; just not where it was mounted.

After the notches were installed, I started to think about bump stops and remembered I still had the originals, so I cleaned them up, made a few tweaks, and present them to you now!

I won’t be installing them until I have the truck sitting with the Shockwaves fully collapsed so I know where it actually needs to be. They’ll be welded to the inside of the frame rails on the step notch.

If you need new bump stops, Energy Suspension has a bunch of options. Check out this reseller’s listing (I find it easier to search than the official website): http://www.energysuspensionparts.com/universal-bump-stops-shock-eyes.asp

Leave a Reply