Dear Welder Series… Frame Curve Radius?

Dear Welder Series…
Hi there. I was hoping to find a horizontally-bent “frame curve” in 2″ x 5″ (3″ x 5″ would be ideal), but your Web site shows only up to 2″ x 4″. Oh well, as this is for a rear bumper that I’m designing, I can make do with the 2″ x 4″.

But I wonder if you can tell me the radius of curvature of the outside curve on your horizontal 2″ x 4″? I would like to match the curved rear quarter panel of a ’76 Toyota Landcruiser, which I believe has a 5″ to 6″ radius of curvature.

Thank you!

Dear Glen…
Glen, the inside radius is 4″ on all of our frame curves. The outside radius would be 6″ on a 2×4 horizontal curve (4″ + 2″).

Thanks for looking at Welder Series parts.

Paul Horton

Leave a Reply