Dear Welder Series… rear shock mounts?

Dear Welder Series…
Mr.Paul Horton.
Found you on the HAMB O’Dex. I have a 1952 Buick Special Lead Sled project. I am at the point where I am in need of rear shock brackets. I have a Ford 9″ rear end installed on a custom 2-link set -up. The fabricator basically fell of the face of the earth before he finished the job. I need upper and lower shock brackets and maybe an upper shock mounting bar. Does this sound like something you can help me with….? What kind of information/measurements do you need from me to get this figured out…..? Please advise…..

thank you, Russell

Dear Russel…
Russ, we have lower shock mounts, http://104.154.121.234/online-store/rear-shock-mount-lower/ , that would weld to your 9″ Ford rear end. For the upper shock mounts, how about our crossmember, http://104.154.121.234/online-store/rear-crossmember-kit/ ? This crossmember is available with either 7/16″ or 5/8″ sleeves. Choose the size that will work with the shocks you get. The crossmember tube is 46″ long. Check the width of your frame to be sure this is long enough.

Thanks for looking at Welder Series parts.

Paul Horton

One comment

  1. Raymond Tschorn says:

    Dear Welder Series,
    Is it possible for you to make a rear triangulated four bar system where the front mounts meet at the same point on the frame and the rear brackets both are on top of the housing. The inner ones of course at a larger angle to the frame?
    Ray

Leave a Reply